- New
- Out-of-Stock
• Micro-controller and strain gauge system.
• One point of measure at 30 mm height.
• Automatic temperature compensation.
• Measures the load up to 40 N.
• Displays three units : kgf , N, oz.
• precision: 1% full scale.
• LCD 16 characters.
• Automatic zero search on starting up.
• Memorization of the displayed value.
• Powered by a 9 V PP3 battery.
• Measurement by impulses.
• Display refresh: once per second.
• Language: French, English, Spanish, German, Italian.
• Dimensions: 80 x 120x 31 mm.
Products from the same category
This block displays recently viewed products
Complete solution with wiper arm load gauge 00407-M, angle measurement device with clip 09392-A (measurement height from windshield 30 mm); calibration set and standard...
Empty storage case designed to hold one wiper arm load gauge, two wiper arm angle gauges, and one calibration set.
• Measures the angle between the wiper arm and the windshield at a height of 20 mm.• Can be fitted with Micronext or third party wiper arm angle gauge modules.• The...
Complete solution with wiper arm load gauge 00403-M; angle measurement device with clip 09392-A (measurement height from windshield 30 mm) with standard adapters; angle...
Wiper arm load gauge 00407-M in its protection case• Micro-controller and strain gauge system• Two points of measure at 30 mm and 7mm height• Automatic temperature...
• Measures the angle between the wiper arm and the windshield at a height of 30 mm.• Equipped with a Clip Module.• Designed to be fitted to the side of the wiper arm.•...
The Clip Module is designed to be fitted to the side of the wiper arm. It allows to connect a wide range of wiper arms.
Complete solution with wiper arm load gauge 00407-M; angle measurement device with clip 09392-A (measurement height from windshield 30 mm) with standard adapters; angle...
• Measures the angle between the wiper arm and the windshield at a height of 30 mm.• Equipped with a T-Shaped Module.• Designed for rear and front APC wiper arms,...
• Measures the angle between the wiper arm and the windshield at a height of 20 mm, • Equipped with a Nose Module. Supplied with 19 & 22 mm width adapters.•...
Wiper arm load gauge 00403-M5 in its protection case• Micro-controller and strain gauge system.• One point of measure at 30 mm height• Automatic temperature...
The T-Shaped Module id designed for rear and front APC wiper arms, extremity designed to connect the calibration set.
check_circle
check_circle